bottom pan mods............
i used a 6x18 22 gauge piece of steel........i messed up and cut it in half.......you will see why later
hardware........bolts, nuts, washers, and lock washers
lines i marked out on the bottom of the pan.........so i could make sure i had enuff space between the sliding piece
here i layed out the pieces to judge my layout and holes to drill, where
drilled holes on the right side, and test ran the side piece to make sure i wasn't TOO far off my lines
this is the top piece......to hold the sliding piece in place
other side done, and both sides bolted in
had to tweak the sides abit to allow easier sliding of the blocking piece
top view, with the slider blocking off the vent hole halfway.........kinda hard to see, just trying to give you guys a idea of the operation
i used black magic marker to scribe lines so when i am cooking, i will know when i have it half way closed........closed........or all the way open
i also used lock tite liquid to make sure the bolts don't come loose
i used a 6x18 22 gauge piece of steel........i messed up and cut it in half.......you will see why later
hardware........bolts, nuts, washers, and lock washers
lines i marked out on the bottom of the pan.........so i could make sure i had enuff space between the sliding piece
here i layed out the pieces to judge my layout and holes to drill, where
drilled holes on the right side, and test ran the side piece to make sure i wasn't TOO far off my lines
this is the top piece......to hold the sliding piece in place
other side done, and both sides bolted in
had to tweak the sides abit to allow easier sliding of the blocking piece
top view, with the slider blocking off the vent hole halfway.........kinda hard to see, just trying to give you guys a idea of the operation
i used black magic marker to scribe lines so when i am cooking, i will know when i have it half way closed........closed........or all the way open
i also used lock tite liquid to make sure the bolts don't come loose
Comment