Announcement

Collapse
No announcement yet.

Smoke Ring Vs. Smoky flavor

Collapse
This topic is closed.
X
This is a sticky topic.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Smoke Ring Vs. Smoky flavor

    Smoky flavor Vs. Smoke Ring with respect to Temperature

    OK, there seems to still be a certain amount of confusion about the amount of "smokiness" imparted to the food in a smoker, and temps.

    The 140° mark is the point where the protein myoglobin will denature, and will no longer "cure" or change color with additional NO (nitrous oxide) from the smoke. This stops the formation of the smoke ring.

    It does NOT stop the ability of food to take on additional flavor from the smoke however.

    On edit: And yes, moisture in the initial phase of the smoking process WILL increase the rate of smoke ring formation

    The above is scientific fact. The below is my observations/opinion:

    The smoke ring is said not to impart much flavor, but in fact it MUST impart some change in flavor, as it's actually a cure in the first 1/4" or so of the food. In a brisket or butt, this would matter little, but in ribs, it will result in a more "hammy" flavor.

    An addendum for you electric unit users- the reason you have little or no smoke ring when using your units is addressed in the last paragraph below. Although apparently burning a chunk of lump in the pan will contribute to the ring formation.


    Below is a paper referring to some of the info I have presented.
    ----------------

    Smoke Ring in Barbeque Meats
    How to Get That Coveted Pink Ring With Your Cooking
    by Joe Cordray

    Slow cooked barbecue meats often exhibit a pink ring around the outside edge of the product. This pink ring may range from 1/8 inch to 1/2 inch thick. In beef the ring is a reddish-pink and in pork, chicken and turkey it is bright pink. This pink ring is often referred to as a "smoke ring" and is considered a prized attribute in many barbecue meats, especially barbecue beef briskets. Barbecue connoiseurs feel the presence of a smoke ring indicates the item was slow smoked for a long period of time. Occasionally consumers have mistakenly felt that the pink color of the smoke ring meant the meat was undercooked. To understand smoke ring formation you must first understand muscle pigment.

    Myoglobin is the pigment that gives muscle its color. Beef muscle has more pigment than pork muscle thus beef has a darker color than pork. Chicken thighs have a darker color than chicken breast thus chicken thigh muscle has more muscle pigment (myoglobin) than chicken breast tissue. A greater myoglobin concentration yields a more intense color. When you first cut into a muscle you expose the muscle pigment in its native state, myoglobin. In the case of beef, myoglobin has a purplish-red color. After the myoglobin has been exposed to oxygen for a short time, it becomes oxygenated and oxymyoglobin is formed. Oxymyoglobin is the color we associate with fresh meat. The optimum fresh meat color in beef is bright cherry red and in pork bright grayish pink. If a cut of meat is held under refrigeration for several days, the myoglobin on the surface becomes oxidized. When oxymyoglobin is oxidized it becomes metmyoglobin. Metmyoglobin has a brown color and is associated with a piece of meat that has been cut for several days. When we produce cured products we also alter the state of the pigment myoglobin. Cured products are defined as products to which we add sodium nitrate and/or sodium nitrite during processing. Examples of cured products are ham, bacon, bologna and hotdogs. All of these products have a pink color, which is typical of cured products. When sodium nitrite is combined with meat the pigment myoglobin is converted to nitric oxide myoglobin which is a very dark red color. This state of the pigment myoglobin is not very stable. Upon heating, nitric oxide myoglobin is converted to nitrosylhemochrome, which is the typical pink color of cured meats.
    When a smoke ring develops in barbecue meats it is not because smoke has penetrated and colored the muscle, but rather because gases in the smoke interact with the pigment myoglobin. Two phenomenon provide evidence that it is not the smoke itself that causes the smoke ring. First, it is possible to have a smoke ring develop in a product that has not been smoked and second, it is also possible to heavily smoke a product without smoke ring development.

    Most barbecuers use either wood chips or logs to generate smoke when cooking. Wood contains large amounts of nitrogen (N). During burning the nitrogen in the logs combines with oxygen (O) in the air to form nitrogen dioxide (NO2). Nitrogen dioxide is highly water-soluble. The pink ring is created when NO2 is absorbed into the moist meat surface and reacts to form nitrous acid. The nitrous acid then diffuses inward creating a pink ring via the classic meat curing reaction of sodium nitrite. The end result is a "smoke ring" that has the pink color of cured meat. Smoke ring also frequently develops in smokehouses and cookers that are gas-fired because NO2 is a combustion by-product when natural gas or propane is burned.

    Let’s review the conditions that would help to contribute to the development of a smoke ring. Slow cooking and smoking over several hours. This allows time for the NO2 to be absorbed into and interact with the meat pigment.

    Maintain the surface of the meat moist during smoking. NO2 is water-soluble so it absorbs more readily into a piece of meat that has a moist surface than one which has a dry surface. Meats that have been marinated tend to have a moister surface than non-marinated meats. There are also a couple of ways that you can help to maintain a higher humidity level in your cooker; 1. Do not open and close the cooker frequently. Each time you open it you allow moisture inside to escape. 2. Put a pan of water on your grill. Evaporation from the water will help increase humidity inside the cooker.

    Generate smoke from the burning of wood chips or wood logs. Since NO2 is a by-product of incomplete combustion, green wood or wetted wood seems to enhance smoke ring development. Burning green wood or wetted wood also helps to increase the humidity level inside the cooker.
    A high temperature flame is needed to create NO2 from nitrogen and oxygen. A smoldering fire without a flame does not produce as much NO2. Consequently, a cooker that uses indirect heat generated from the burning of wood typically will develop a pronounced smoke ring. Have fun cooking. A nice smoke ring can sure make a piece of barbecued meat look attractive.

    About the Author:

    Joe Cordray is the Meat Extension Specialist at Iowa State University’s nationally renowned Meat Lab, located in Ames, IA. He has been writing for The BBQer since Fall of 2001
    Last edited by Richtee; 02-08-2009, 06:18 AM.
    In God I trust- All others pay cash...
    Check out the Mad Hunky and products at https://madhunkymeats.com or https://www.facebook.com/MadHunkyMeats
    Lang 60D, The Beast, 18 and 22 WSM, Brinkmann Backroads trailer, Weber 22 Kettle, gutted MB burning watts
Working...
X